Ok- fantastic!- lets go for it. Some minor points... do we have the plexiglas/ is the size confirmed?.. also do we hang it or project it off of the wall with bolts and adjust the lighting? And can it say unit staff- or can we go at the top please..... thanks Erin
I rang negs for another quote because neill had rang and the prices seemed to vary. It ended up being £150 for it cut and for them to fit it, not much cheaper for us to do it ourselves ( and the guy said we would be likely to mess it up) Would it just be better to stencil the writing on the acrylic? Otherwise i think this way is going to be way too expensive... The original measurements were 1.3m x 0.8m It can be shrunk but it will still be just as expensive. Also no problem on swapping the names round!
If you think that you can laser cut the stencil... or hand cut.. then cool. could also be very good...maybe check with Fred about the Plexiglas too- thanks
6 comments:
Got a quote from negs for £50/sqm.
They have lots of greens so we should be able to get as close to paint as pos.
Ok- fantastic!- lets go for it. Some minor points... do we have the plexiglas/ is the size confirmed?.. also do we hang it or project it off of the wall with bolts and adjust the lighting? And can it say unit staff- or can we go at the top please..... thanks Erin
Just realised it said per square metre... can we please fit graphics into 1 sqm... otherwise the budget is well and truly blown... thanks
I rang negs for another quote because neill had rang and the prices seemed to vary. It ended up being £150 for it cut and for them to fit it, not much cheaper for us to do it ourselves ( and the guy said we would be likely to mess it up) Would it just be better to stencil the writing on the acrylic? Otherwise i think this way is going to be way too expensive...
The original measurements were 1.3m x 0.8m It can be shrunk but it will still be just as expensive.
Also no problem on swapping the names round!
Oh i just thought satin spray paint would probably look nice ( and be a matching colour) and if we make a stencil it would be just as precise.
If you think that you can laser cut the stencil... or hand cut.. then cool. could also be very good...maybe check with Fred about the Plexiglas too- thanks
Post a Comment